http://www.laphua1989.com  NewsType：industry  publisher：mardy  Datetime：2015-12-30  Views：5832

Silicone rubber products, cleaning method

   Silicone rubber products industry, to remove the mold in the dirt, has been a headache thing, as vulcanized rubber, silicone rubber products required at a high temperature, some of the rubber compound remain in the silicon rubber mold of oil and chemicals Drugs, by the time required to form a high temperature coking stubborn dirt. Use LW303 wash-water can remove all the dirt in an instant. LW303 super wash-water contains a special accelerator with the molds for mold cleaning agent, the conventional mold cleaning agents often due to lack of clean power, must meet the metal brush to remove stubborn dirt or sand on the mold, and they often cause mold damage , the FDA required a small amount of liquid or diluted liquid sprayed on the mold surface, in a very short period of time, you can completely clean and remove stubborn dirt, without damaging the mold, extending its life. Silicon rubber mold cleaning, tire mold cleaning, mold cleaning rubber seals, silicone rubber mold cleaning the preferred LW303 wash-water to solve:

First, wash-water nature of use:
LW-303 [wash-water] of high-quality mold cleaning agents, dirt and mold any serious moment completely clear, easy to use, not damage mold, but also extend the life of mold.

Second, use:
1, spreading method: Use a small amount of liquid or dilution spreading or smear on the high temperature of the mold, wait 2 - 3 minutes will soften the dirt was free in front of wash-water does not dry immediately rinse with water, mold temperature above 95 ℃.
2, impregnation method: iron tank containing liquid or diluent, heating accounts for about 95 ℃ after soaking for about 2-3 minutes. Or directly into the mold at a high temperature of the solution at room temperature, soak for 2-3 minutes then rinse with water taken from the can.

Previous：Material analysis of silicone tube and silicone

Next：Silica gel desiccant characteristics